Siemens NX

Table of Contents

• Overview
• Scope
• Known Limitations

Overview

ModelData.ModelReader reads Siemens NX (Designcenter) part files (.prt) from versions v5 (2007) to v2606.

Scope

Import
B-Rep representations body names

Known Limitations

Only part files are supported. Siemens NX assembly files use the same .prt extension, but assembly import is not supported.

Note

Do not confuse Siemens NX .prt files with Creo .prt files. Creo files are not supported.

Conversion of complex procedural geometry may produce errors or inaccurate results. When such an error is detected, the affected geometry is replaced with a spline approximation, which may be less accurate than the original geometry.

If you encounter inaccurate results, contact Support.